Friday, September 18, 2026

cloisonné process photo essay

in which our plucky heroine shares the way that my cloisonné enamels are created...

Here is the start, bending the wires to create the outlines of the design

And here you see the all the wires for the design

The first several firings locate the wires on the backing

Then more enamel powder gets added

and the colored design is gradually built up

There are many more steps in the process before the enamel is finished and ready to be set as part of the pendant

Once enough layers of enamel are built up, the irregular surface needs to be ground smooth. Here you can see the beginning of the process, which I find the most tedious part of enameling. The grinding is usually done with a white aluminum oxide stick, by hand, under cold running water.

and here it is further ground down, almost ready for firing

After the first "flash-firing", there are often small areas that need a bit of extra enamel to bring it all up to an even surface. This is preferable to grinding down too far, and maybe losing some of the carefully applied shading.

And here is the piece, ready to have a suitable setting made for it...



Just in case you wondered where I do this kind of work, here is a picture of my kiln (nicknamed "Mr Hot" by my friend Heather when she was about 9 years old), and a bit of one of my workspaces, much less messy than usual

No comments:

Post a Comment

Dear friends: your courteous and interesting comments will soon show up here once read and approved, but spammers and trolls will have to play somewhere else. It helps if you add your name to your comment, so I know who you are... Please be patient, as I am sorry that this layer of moderation is now needed